Lead Pipe Info

What is lead?
Lead is a soft, malleable metal that was once used in items from gasoline to paint. Due to its adverse health effects, the federal government began limiting its use in the 1980s.

 

Does Dade County’s water have lead?
No, lead does not occur naturally in our source water. Lead also does not come from our water treatment plants or our water distribution system. Dade County’s water distribution system contains no known lead piping. The distribution system contains trace amounts of lead in solder on some older pipes and brass fittings used at meters. Since 2014, we have only used lead-free brass fittings and continue to proactively replace older components in our system.

 

Where does lead come from?
The main source of lead in drinking water is from private plumbing systems. It can come from lead solder used in service lines running between the water main in the street and the home, as well as from plumbing inside the home.  

Although lead soldering of copper water pipes was banned in Georgia in 1986, some homes may still contain these plumbing systems. Per federal regulation, we test locations with these “at-risk” plumbing systems.

 

Is lead in drinking water regulated?
Yes, the EPA regulates lead through the Lead and Copper Rule section of the Safe Drinking Water Act. The rule requires utilities to test tap water from a sampling of homes in the county. Lead levels should be below 15 parts per billion (ppb) for 90 percent of the samples tested. Water from Dade County Water & Sewer Authority has consistently met this EPA standard.

 

What were the results of Dade County’s most recent lead testing?
Per federal regulations, we test homes located throughout the county to ensure that our corrosion control is effective. When testing for lead, 90 percent of all samples tested must be less than the 15 ppb action level (AL). This means that out of every 10 homes sampled, nine must be at or below this level. Because our lead levels have remained consistently low, we are only required by EPA to conduct lead sampling once every three years. 

If you’re concerned about lead in your home

Because many of the homes in Dade County are newer, we have fewer homes with lead plumbing or lead-based solder than other communities; however, some homes may still have lead in their plumbing:

  • Homes built before 1970 have a greater chance of having partial lead plumbing.
  • Homes build prior to 1987 may have lead solder connecting copper pipes.
  • Homes built after 1985 are significantly less likely to have a significant amount of lead in the plumbing.
  • Homes built after 2014 have the least amount of lead, as even the brass fittings used in these dwellings are required to meet stringent lead requirements.


If you have lead solder or other lead sources in your home plumbing, here are some steps you can take to further reduce lead:

  • If water has been sitting in your pipes for an extended period of time (more than six hours), flush the line by letting the cold water faucet run for one to two minutes before using the water for drinking or cooking.
  • Only use cold water for cooking and drinking. Lead leaches more easily into hot water.
  • Clean out the aerators (screens on the faucet) periodically. Over an extended period of time, these screens can trap sediment and debris. They twist off easily and can be cleaned or replaced, if needed.